Issue |
MATEC Web Conf.
Volume 156, 2018
The 24th Regional Symposium on Chemical Engineering (RSCE 2017)
|
|
---|---|---|
Article Number | 01016 | |
Number of page(s) | 6 | |
Section | Biochemical and Biomedical Engineering | |
DOI | https://doi.org/10.1051/matecconf/201815601016 | |
Published online | 14 March 2018 |
Optimization of Glucose Production of Cocopeat Using Whole Cell Trichoderma reesei
Chemical Engineering Departement, Faculty of Engineering, Syiah Kuala University
* Corresponding author: m.zaki@che.unsyiah.ac.id
The high content of cellulose in cocopeat makes this material convertible into glucose. The converting process of cellulose into glucose can be done by hydrolysis. In this research, the coocopeat hydrolyzed enzymatically using cellulose ezyme from Trichoderma reesei. The purpose of this study was to obtain optimum conditions of glucose yield and to know the effect of concentration of NaOH, molasses mass, and the effect of hydrolisis time on glucose yield produced. The variabel used was hydrolisis time (0; 124; and 240 hour), NaOH concenteration (1%; 2%; and 3%), and molasses mass (40; 50; and 60 gr/l). The result showed the higest glucose level obtained at 2% NaOH concenteration, molasses mass 60 gram, and hydrolysis time 240 hours, while the predicted resulted of the optimum conditions of glucose level produced using the software Design Expert 6.08 is 776.771 mg/l at NaOH concenteration 1,35%, molasses mass 59.96 mg/l and hydrolisis time 215.62 hours.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.