MATEC Web Conf.
Volume 153, 2018The 4th International Conference on Mechatronics and Mechanical Engineering (ICMME 2017)
|Number of page(s)||5|
|Section||Modeling and Simulation of Mechanical System|
|Published online||26 February 2018|
Experiment and simulation study on relationship between diameter of high-pressure water abrasive jet nozzle and cutting capacity
Guilin University of Electronic Technology, Guilin. Guangxi, China
High pressure water abrasive jet nozzle is key part of the particles acceleration. The diameter of nozzle has important effect for jet fluid. Through experiment and simulation explore the relationship between nozzle diameter and jet fluid cutting capacity. The result indicate: ①the cut depth and broad reduced in linearly relationship with the diameter of the jet nozzle. ②In same pressure, decrease the nozzle diameter will reduce the cutting ratio energy; ③The acceleration and attenuation of the nozzle axial flow in different diameters are basically consistent, The smaller nozzle diameter, The flow acceleration will slower, the attenuation will faster, the is velocity core segment will shorter and the cutting ability will lower;Consider from energy consumption, cutting efficiency and other factors, for common material cutting the nozzle preferred diameter is: 0.6~1.0mm, it’s unfavourable to select the 0.2mm diameter
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.