| Issue |
MATEC Web Conf.
Volume 249, 2018
2018 5th International Conference on Mechanical, Materials and Manufacturing (ICMMM 2018)
|
|
|---|---|---|
| Article Number | 02004 | |
| Number of page(s) | 5 | |
| Section | Mechanical System Modeling and Analysis | |
| DOI | https://doi.org/10.1051/matecconf/201824902004 | |
| Published online | 10 December 2018 | |
A dynamic machine tool circle test calibration method by R-test
School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai, 200240, PR China
With the continuous popularization of automation in the manufacturing industry and continuous improvement of production efficiency, new requirements have been put forward for the error detection of machine tool. As a new automated detection tool, R-test has been widely studied by scholars. This paper proposes a dynamic test method for R-test, and analyses the influence of three main error sources of servo error, pitch error and reading error. The corresponding elimination methods are also introduced. An experiment on a double turntable machine tool was conducted to verify the analysis. In addition, the selection of feed rate and initial position in circle test is also studied.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.