MATEC Web Conf.
Volume 246, 20182018 International Symposium on Water System Operations (ISWSO 2018)
|Number of page(s)||4|
|Section||Parallel Session II: Water System Technology|
|Published online||07 December 2018|
Hardware Platform Design for Baseband Data Transmission of WCDMA Based on USB3.0
1 Department of Electronic Engineering, Tsinghua University, Beijing, China
2 Innovem Technology (Tianjin) Co., Ltd, Tianjing, China
a Corresponding author: firstname.lastname@example.org
This paper proposes a hardware platform for WCDMA baseband data transmission, which consists of USB3.0 interface, general purposes processor (GPP), and software defined radio (SDR) system. In view of the requirements of WCDMA system, the hardware platform consisting of USB3.0 controller, FPGA and DDRII was selected, which finally realized the high throughput rate and low delay transmission of baseband data of WCDMA system. The experimental results show that in this GPP software defined radio system, the interface speed of USB3.0 can reach 200MBps, and the loopback delay time of the system is about 0.7ms, which can meet the requirements of WCDMA system.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.