MATEC Web Conf.
Volume 137, 2017Modern Technologies in Manufacturing (MTeM 2017 - AMaTUC)
|Number of page(s)||8|
|Section||Machining Processes and Quality Assurance|
|Published online||22 November 2017|
Tracking of the development wear of cutting tools with different geometry during parting-off
1 Faculty of Mechanical Engineering, VŠB-TU Ostrava, 17. listopadu 15/2172, Ostrava-Poruba, 708 33, Czech Republic
2 Faculty of Machine Building, Technical University of Cluj-Napoca, Memorandumului street, nr. 28, Cluj-Napoca, 400114, Romania
* Corresponding author: firstname.lastname@example.org
The article deals with the tracking of the wear development of cutting tools made from sintered carbide during parting-off of steel C45 (ČSN 12 050.1). For experiment were selected inserts from two producers of cutting tools with different geometry. The parting-off was realized in the workpiece axis and the whole experiment was divided into two parts, parting-off to zero and parting-off to pre-drilled hole into material. The experiment was evaluated on the principle direct microscopic method and was observed the wear on the flank of cutting tool VBB. Tests were realized in cooperation with Pramet Tools Šumperk, Czech Republic.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.