Issue |
MATEC Web Conf.
Volume 130, 2017
The International Conference on Composite Material, Polymer Science and Engineering (CMPSE2017)
|
|
---|---|---|
Article Number | 09004 | |
Number of page(s) | 4 | |
Section | Tribology of polymer and composite materials | |
DOI | https://doi.org/10.1051/matecconf/201713009004 | |
Published online | 25 October 2017 |
Observation of fracture behavior of 3-D printed specimens under rolling contact fatigue in water
University of Toyama, Department of mechanical engineering, 3190 Gofuku, Toyama, Japan
a Corresponding author: kmizobe@eng.u-toyama.ac.jp
Polymer bearing was widely used in the corrosive conditions because of its high corrosion durability. The polymer bearing had been formed using molding and machining until the new 3-D printing method was developed. In this study, we performed the rolling contact fatigue tests of the 3-D printed specimens in water and observed the fracture behaviour of the specimens. We found that the surface cracks are related to both the rolling direction and the lamination directions.
© The authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.