MATEC Web Conf.
Volume 129, 2017International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|Number of page(s)||3|
|Section||Modelling of Technical Systems. CAD/CAM/CAE Systems|
|Published online||07 November 2017|
Using a discrete product model to determine the design element junctures
Irkutsk National Research Technical University, 664074, Irkutsk, Russian Federation
* Corresponding author: email@example.com
This paper describes a discrete model of a standard airframe part. The model is intended for determining the junctures between the design elements of a node (unit) in the pre-assembly procedures. We herein propose an algorithm selecting base surfaces for basing the product being assembled; selections are made on the basis of the 3D model of such product.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.