MATEC Web Conf.
Volume 129, 2017International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017)
|Number of page(s)||3|
|Section||Advanced Materials and Coatings|
|Published online||07 November 2017|
Heat treatment of composite based on MAX-phases of the Ti-Al-C system
Ufa State Aviation Technical University, 450000, Ufa, Russia
2 Russian Academy of Sciences Institute of Structural Macrokinetics and Materials Science RAS, 142432, Chernogolovka, Russia
* Corresponding author: firstname.lastname@example.org
This paper studies the effect of heat treatment performed at the MAX-phases formation temperature on the phase composition of the MAX/TiC-composite formed in the Ti–Al–C system in the conditions of free SHS-compression. The dependence between the titanium carbide (TiC) content and delay time before applying the load during free SHS-compression is defined. The experimental results show that the proposed heat treatment leads to carbide content reduction.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.