| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 07021 | |
| Number of page(s) | 6 | |
| Section | Mechanical and Manufacturing Equipment, Devices and Instrumentation, Design and Analysis | |
| DOI | https://doi.org/10.1051/matecconf/201711207021 | |
| Published online | 03 July 2017 | |
Design and manufacturing front hood for electric vehicle by carbon fibber
1 Technical University of Cluj-Napoca, Manufacturing Engineering, Blvd. Muncii 103-105, Romania
2 Technical University of Cluj-Napoca, Design Engineering and Robotics, Blvd. Muncii 103-105, Romania
3 Technical University of Cluj-Napoca, Mechanical Engineering department, Blvd. Muncii 103-105, Romania
* Corresponding author: calin.neamtu@muri.utcluj.ro
The polymeric reinforced composite materials (FRP) are a new materials group which have a lot of research reported in the last years. Our paper present the results obtained in case of use FRP for manufacturing an electric vehicle front hood in order for lightweight chassis and increase the autonomy. The design stage and 3D modelling of the mould, material design and manufacturing front hood from Carbon Fibber/Epoxy are presented.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.