| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 06008 | |
| Number of page(s) | 6 | |
| Section | CAD/CAM/CAE/CAX Technologies, Manufacturing Optimization | |
| DOI | https://doi.org/10.1051/matecconf/201711206008 | |
| Published online | 03 July 2017 | |
Hob mill for spline shaft, profiled by generating trajectories method. Graphical application in CATIA
“Dunărea de Jos” University of Galaţi, Department of Manufacturing Engineering, Domnească 111, Galaţi, Romania
* Corresponding author: virgil.teodor@ugal.ro
The hob mill is a cutting tool with a wide application for generation in machining of splined shafts. A method for profiling the hob mill for generation of square splines is presented in this paper. The analytical development was done based on a complementary theorem of surface enwrapping — the method of generating trajectories. A numerical application for a standardized spline shaft is presented. Based on the same theorem is presented a graphical application, developed in the CATIA design environment, for profiling the hob mill which generated standardised square splines.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.