Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
---|---|---|
Article Number | 01015 | |
Number of page(s) | 6 | |
Section | Advanced Machining and Surface Engineering | |
DOI | https://doi.org/10.1051/matecconf/201711201015 | |
Published online | 03 July 2017 |
Tool material, tool wear and machined hole quality evaluation at CFRP drilling
1 Technical University of Cluj-Napoca, Faculty of Mechanical Engineering, Department of Manufacturing Engineering, BulevardulMuncii 103-105, Cluj-Napoca, Romania
2 Gühring KG, Herderstraße 50-54, Albstadt, Germany
3 Gühring S.R.L., Transilvaniei 12, Baciu, Romania
* Corresponding author: jugrestan_claudiu@yahoo.com
Because of increasingly stricter safety rules, requirements regarding the quality of the components used in the airline industry have increased. Besides the materials used in aircraft components and areas where they are machined, these components must comply certain standards for quality and tolerances of the machined surfaces.Due to high hardness of carbon fibers, hole machining in carbon fiber reinforced plastics has always been a challenge. Wear that occurs in the cutting tool leads to the appearance of workpiece defects such as delamination, peeling, fiber pulling out, etc. Besides cutting tool geometry, a very important role on tool wear, it is owned by the material from which it is made. This paper will make a quantitative assessment of defects that occur in the process of CFRP (carbon fiber reinforced plastics) drilling and a cutting tool wear evaluation. In order to obtain conclusive results for this study will be used three drill bits with the same geometry but different carbides.The aim of this paper is to find which one of this three carbide used is more feasible for holes machining in composite materials reinforced with carbon fibers.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.