| Issue |
MATEC Web Conf.
Volume 94, 2017
The 4th International Conference on Computing and Solutions in Manufacturing Engineering 2016 – CoSME’16
|
|
|---|---|---|
| Article Number | 02013 | |
| Number of page(s) | 5 | |
| Section | Advanced Manufacturing Technologies | |
| DOI | https://doi.org/10.1051/matecconf/20179402013 | |
| Published online | 04 January 2017 | |
Dynamic study of milling low depth channels
Transilvania University of Brasov, Department of Manufacturing Engineering, Mihai Viteazu No.5, Braşov, Romania
* Corresponding author: m.folea@unitbv.ro
This paper presents a study of dynamic aspects of the milling cutters used in particular case of low depth channels. A new calculation method was developed, taking into account the high variations of cutting forces during milling small depth channels with peripheral cutting tools. A new formula was established for the minimal value of channel depth that allows cutting process to be performed in conditions of dynamic stability.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.