MATEC Web Conf.
Volume 80, 2016NUMIFORM 2016: The 12th International Conference on Numerical Methods in Industrial Forming Processes
|Number of page(s)||6|
|Section||MS4: Advanced modeling of contact interfaces in forming|
|Published online||24 October 2016|
Modeling of the roll wear and material damage during high-ratio differential speed rolling of aluminium alloy 7075
Nosov Magnitogorsk State Technical University, Department of Material processing, 455000, Magnitogorsk, Lenin prospect, 38, Russia
a Corresponding author: email@example.com
The technology of high-ratio differential speed rolling (HRDSR) with high contact friction can be used for production of aluminium alloys with UFG structure. But a high friction coefficient is not desirable because of the increasing of the material damage. The paper presents a numerical analysis of the rolls wear and material damage during HRDSR of aluminium alloy 7075. The FEM was used to calculate the rolls wear by Archard’s model and material damage by normalized Cockroft-Latham model.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.