| Issue |
MATEC Web Conf.
Volume 76, 2016
20th International Conference on Circuits, Systems, Communications and Computers (CSCC 2016)
|
|
|---|---|---|
| Article Number | 02023 | |
| Number of page(s) | 5 | |
| Section | Systems | |
| DOI | https://doi.org/10.1051/matecconf/20167602023 | |
| Published online | 21 October 2016 | |
Mechanical Properties of Injection Molded and Compression Molded Samples from Nature-Butadiene Rubber
Tomas Bata University in Zlin, TGM 5555, 760 01 Zlin, Czech Republic
a Corresponding author: skrobak@ft.utb.cz
The aim of this paper is to show what extent there is an impact on the mechanical properties (tensile strength and tear strength) of a standardized testing sample made of rubber compound based on nature rubber and butadiene rubber produced by injection molding in comparison with a sample produced by classic preparation (cutting out a compression molded plate) according to the standard ISO 23529. For realization of this study it was necessary to design and produce an injection mold for all types testing samples. Subsequently, mechanical properties such as the tensile stress-strain and tear strenght of compression molded samples and injection molded samples were studied, compared and discussed.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.