MATEC Web Conf.
Volume 67, 2016International Symposium on Materials Application and Engineering (SMAE 2016)
|Number of page(s)||6|
|Section||Chapter 4 Surface Engineering and Coating Technology|
|Published online||29 July 2016|
Effect of Specimen Size on Laser Scribing Width and Depth of Al2O3 Ceramics: Experiment and Numerical Simulation
1 State Key Laboratory of Materials Processing and Die & Mould Technology, Huazhong University of Science and Technology, Wuhan 430074, P.R. China
2 Xi’an Technological University, Shaanxi Key Laboratory of Non-Traditional Machining, Xi’an 710021, P.R. China
To obtain high precision and quality of laser ceramic scribing , people should consider the laser scribing parameters and the geometries of specimen size. In this paper, the effect of specimen size on laser scribing width and depth of Al2O3 ceramics was simulated and verified by using ANSYS software and Diode Pumped Solid State (DPSS) laser scribing, respectively. The calculated results and the experimental results all proved that the specimen size had important effect on laser scribing width and depth due to the heat accumulation effect during laser scribing.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.