Issue |
MATEC Web Conf.
Volume 63, 2016
2016 International Conference on Mechatronics, Manufacturing and Materials Engineering (MMME 2016)
|
|
---|---|---|
Article Number | 01009 | |
Number of page(s) | 5 | |
Section | Mechatronic and Application Engineering | |
DOI | https://doi.org/10.1051/matecconf/20166301009 | |
Published online | 12 July 2016 |
A New Cold Rotary Forging Technology for Automotive Starter Guiding Cylinder with Internal Helical Involute Spline
School of Mechanical Engineering, Yancheng Institute of Technology, 224051 Yancheng Jiangsu, China
a Corresponding author: wp_ycit@163.com
A new cold rotary forging technology of the internal helical involute spline was presented based on an analysis of the structure of automotive starter guide cylinder. 3D rigid-plastic finite element model was employed. Billet deformation, Billet equivalent stress and forming load were investigated under the DEFORM 3D software environment, then the forming process parameters were applied in the forming trials, and the simulation results are conformed with the experimental results. The validity of 3D finite element simulation model has been verified. The research results show that the proposed cold rotary forging technology can be efficient in handling of the forming manufacturing problems of automobile starter guide cylinder with internal helical involute spline.
© Owned by the authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.