| Issue |
MATEC Web of Conferences
Volume 28, 2015
2015 the 4th International Conference on Advances in Mechanics Engineering (ICAME 2015)
|
|
|---|---|---|
| Article Number | 02001 | |
| Number of page(s) | 9 | |
| Section | Mechanical design manufacturing and automation | |
| DOI | https://doi.org/10.1051/matecconf/20152802001 | |
| Published online | 28 October 2015 | |
In-Process Chatter Detection in Surface Grinding
Department of Industrial Engineering, Faculty of Engineering, Chulalongkorn University, Phayathai Road, Patumwan, Bangkok, 10330, Thailand
a Corresponding author: somkiat.t@eng.chula.ac.th
The chatter causes the poor surface finish during the surface grinding. It is therefore necessary to monitor the chatter during the process. Hence, this research has proposed the in-process chatter detection in the surface grinding process by utilizing the dynamic cutting forces. The ratios of the average variances of three dynamic cutting forces have been adopted and applied to identify the chatter during the surface grinding process to eliminate the effects of the cutting conditions. The effects of the cutting conditions on the chatter are also studied and analyzed. The algorithm has been proposed to detect the chatter regardless of the cutting conditions. The verification of the proposed system has been proved through another experiment by using the new cutting conditions. The experimental results have run satisfaction. It is understood that the chatter can be avoided during the in-process surface grinding even though the cutting conditions are changed.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.