MATEC Web of Conferences
Volume 21, 20154th International Conference on New Forming Technology (ICNFT 2015)
|Number of page(s)||6|
|Published online||10 August 2015|
Study on micro extra deep drawing process with ultrahigh fluid pressure and press motion controls
1 Tokyo Metropolitan University, Department of Mechanical Engineering, 1-1, Minamiosawa, Hachioji, Tokyo 192-0397, Japan
2 LLC) Micro Fabrication Laboratory, Seki-building 2-9-22 Myoujin, Hachioji, Tokyo 192-0046, Japan
a Corresponding author: e-mail: email@example.com
A novel micro extra deep drawing process with ultrahigh fluid pressure and press motion controls are developed. A space between the blank and 1st punch is made by the press motion at the 2nd drawing stage and the ultrahigh pressure is applied so as to be disappeared this space. It can enhance a material flow into the die cavity because the ultrahigh pressure acts on the blank at side wall. In addition, a friction holding effect occurs, which prevents the thickness reduction at punch shoulder and side wall. Due to these mechanisms, the micro cup with aspect ratio of 2.0 can be successfully fabricated by micro extra deep drawing in FE simulation, although it cannot be fabricated by conventional micro deep drawing and micro hydromechanical deep drawing.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.