| Issue |
MATEC Web Conf.
Volume 121, 2017
8th International Conference on Manufacturing Science and Education – MSE 2017 “Trends in New Industrial Revolution”
|
|
|---|---|---|
| Article Number | 03007 | |
| Number of page(s) | 5 | |
| Section | Advanced Manufacturing Technologies | |
| DOI | https://doi.org/10.1051/matecconf/201712103007 | |
| Published online | 09 August 2017 | |
Technological aspects regarding machining the titanium alloys by means of incremental forming
Lucian Blaga University of Sibiu, Department of Industrial Machines and Equipment, 550025 Victoriei 10, Sibiu, Romania
* Corresponding author: octavian.bologa@ulbsibiu.ro
Titanium alloys are materials with reduced formability, due to their low plasticity. However, today there are high demands regarding their use in the automotive industry and in bio-medical industry, for prosthetic devices. This paper presents some technological aspects regarding the machinability of titanium alloys by means of incremental forming. The research presented in this paper aimed to demonstrate that the parts made from these materials could be machined at room temperature, in certain technological conditions.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.