Ways to reduce the error of additive methods of forming
MATEC Web Conf., 226 (2018) 01002
Published online: 2018-11-07
Articles citing this article
The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).
Cited article:
This article has been cited by the following article(s):
Investigation of the effect of the angle of inclination of the receiving surface on the displacement of a single deposited layer during additive shaping by an electric arc in a protective gas medium
V. V. Kuts, A. N. Grechukhin and A. S. PrivalovProceedings of the Southwest State University 28 (3) 25 (2024)
https://doi.org/10.21869/2223-1560-2024-28-3-25-35
Proceedings of the 7th International Conference on Industrial Engineering (ICIE 2021)
A. N. Grechukhin, V. V. Kuts and P. S. ShcherbakovLecture Notes in Mechanical Engineering, Proceedings of the 7th International Conference on Industrial Engineering (ICIE 2021) 279 (2022)
https://doi.org/10.1007/978-3-030-85230-6_33
Technological Capabilities Extension of Additive Forming Methods Using Parallel-Serial Structures
A. N. Grechukhin, V. V. Kuts, A. V. Oleshitsky and M. S. RazumovProceedings of the Southwest State University 23 (6) 34 (2020)
https://doi.org/10.21869/2223-1560-2019-23-6-34-44
Proceedings of the 5th International Conference on Industrial Engineering (ICIE 2019)
A. N. Grechukhin, V. V. Kuts and M. S. RazumovLecture Notes in Mechanical Engineering, Proceedings of the 5th International Conference on Industrial Engineering (ICIE 2019) 239 (2020)
https://doi.org/10.1007/978-3-030-22041-9_28
Control Mechanisms of Additive Shaping Error with the Use of Hybrid Design Devices
A. N. Grechukhin, V. V. Kuts, A. V. Oleshitsky and M. S. RazumovProceedings of the Southwest State University 23 (5) 23 (2019)
https://doi.org/10.21869/2223-1560-2019-23-5-23-34
2201 020004 (2019)
https://doi.org/10.1063/1.5138378
2201 020003 (2019)
https://doi.org/10.1063/1.5138377
Control of geometrical parameters of a single layer at additive forming of products by FDM technology
A N Grechukhin, V V Kuts and A V OleshitskyIOP Conference Series: Materials Science and Engineering 680 (1) 012004 (2019)
https://doi.org/10.1088/1757-899X/680/1/012004