Article references

Articles citing this article

The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).

Cited article:

Triaxial analysis of residual stress in surface layers after high feed machining using X-ray diffractometer

Michal Sajgalik, Tatiana Czanova, Lucia Zauskova, Mario Drbul, Marek Sadilek, Jan Valicek

MATEC Web Conf., 157 (2018) 07012

Published online: 2018-03-14

DOI: https://doi.org/10.1051/matecconf/201815707012

This article has been cited by the following article(s):

Fractional-order modelling and system identification of a permanent-magnet induction flowmeter for ionically conductive liquids

Radek Boháč, Leoš Kukačka, Petr Bílek and Lubomír Slavík
Measurement Science and Technology 37 (15) 155007 (2026)
https://doi.org/10.1088/1361-6501/ae5c2a

Comparison of Residual Stresses in Tools Used in the Automotive Industry: Conventional vs. Innovative Heat Treatment for Cost-Effectiveness and Efficiency

Peter Špuro, Michal Sajgalik, Jozef Mrazik, Andrej Czan, Richard Joch, Mario Drbul and Jaromir Markovic
Transportation Research Procedia 93 471 (2026)
https://doi.org/10.1016/j.trpro.2025.11.072

Proposal for the identification of residual stresses after turning and hardening of bearing steel

Marek Šafář, Jan Valíček, Marta Harničárová, Michal Šajgalík, Hakan Tozan, Milena Kušnerová, Mário Drbúl, Milan Kadnár and Andrej Czán
Frontiers in Materials 10 (2023)
https://doi.org/10.3389/fmats.2023.1238816

Vehicle and Automotive Engineering 4

Dmytro Borysenko, János Kundrák, Bernhard Karpuschewski, et al.
Lecture Notes in Mechanical Engineering, Vehicle and Automotive Engineering 4 648 (2023)
https://doi.org/10.1007/978-3-031-15211-5_54

Wear and residual stress in high-feed milling of AISI H13 tool steel

Altug Bakirci, Selim Koca, Ozlem Erdogan and Mustafa Cemal Cakir
Materials Testing 65 (12) 1845 (2023)
https://doi.org/10.1515/mt-2023-0144

Experimental investigations of effect of tempering on residual stresses developed during the turning operation

Rajesh Kumar Maurya and M.S. Niranjan
Materials Today: Proceedings 47 3852 (2021)
https://doi.org/10.1016/j.matpr.2021.03.411