| Issue |
MATEC Web Conf.
Volume 332, 2021
19th International Conference Diagnostics of Machines and Vehicles “Hybrid Multimedia Mobile Stage”
|
|
|---|---|---|
| Article Number | 01010 | |
| Number of page(s) | 7 | |
| DOI | https://doi.org/10.1051/matecconf/202133201010 | |
| Published online | 06 January 2021 | |
Assessment of the surface and structure of elements produced in additive manufacturing technology after chemical treatment
UTP University of Science and Technology, Department of Manufacturing Techniques, Al. prof. S. Kaliskiego 7, 85-796 Bydgoszcz, Poland
* Corresponding author: dawid.marciniak@utp.edu.pl
Samples made of ABS material were produced on devices from three different manufacturers: Stratasys, Velleman, 3Novatica. The quality of the printed surface was improved by vaporization with acetone vapours. Roughness measurements were performed, which proved the improvement of the surface after vaporization. The structure of the produced samples was also tested using a computer microtomography. It has been shown that excessive exposure to the solvent significantly changes the geometrical dimensions of models exposed to the vaporization process.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.