MATEC Web Conf.
Volume 331, 2020International Conference on Urban Disaster Resilience (ICUDR 2019)
|Number of page(s)||9|
|Section||Instrumentation, Control System and Information Technology|
|Published online||09 December 2020|
Comparison of load resistor and battery on controlling buck boost converter using fuzzy-pi method
Department of Electrical Engineering, Tadulako University, Palu, Indonesia.
* Corresponding author : email@example.com
This paper discusses about controlling the buck boost converter output voltage remains constant by comparing of loads resistor and battery. Buck boost converter output voltage tends to be unstable when given a disturbance with a variety of loads, for that it needs proper control to adjust the duty cycle. The controls that will be used are a combination of conventional control methods, i. e. Proportional Integral (PI) and intelligent control, i. e. Fuzzy logic. The results show that the combination of PI control and Fuzzy Logic can improve performance, i. e. small errors close to zero and the buck boost converter output voltage remains constant even though the load is varied, i. e. resistors and battery.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.