MATEC Web Conf.
Volume 319, 20202020 8th Asia Conference on Mechanical and Materials Engineering (ACMME 2020)
|Number of page(s)||6|
|Published online||10 September 2020|
Process Control Improvement in Deep Drawing of Hemispherical Cups Made of GLARE Material
School of Mechanical Engineering and Automation, Beihang University, Beijing, China.
* Corresponding author: firstname.lastname@example.org
Controlling the material flow under the blank holder in hydroforming is a delicate point that can be controlled by the blank holder force (BHF), cavity pressure (CP) and the blank holder gap (BHG). BHG is one of the effective parameters to control the material flow. A numerical and experimental approach studied the impact of the BHG on the Hydromechanical Deep Drawing (HDD) of a hemispherical cup made with 2/1 Glare sheets, including another two factors, CP and BHF. BHGs with different thickness was used in the experiments to form Glare Laminate. Simulation and experiment illustrate that an optimized value of these parameters has a good effect on the forming quality and depth of the final product. Finally, an appropriate value of the BHG is projected and the explanations of the failure modes are discussed.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.