| Issue |
MATEC Web Conf.
Volume 291, 2019
2019 The 3rd International Conference on Mechanical, System and Control Engineering (ICMSC 2019)
|
|
|---|---|---|
| Article Number | 02009 | |
| Number of page(s) | 5 | |
| Section | Mechanical Engineering | |
| DOI | https://doi.org/10.1051/matecconf/201929102009 | |
| Published online | 28 August 2019 | |
Modelling and Rapid Prototyping of Centrifugal Pump Impeller Based on UG
1 Engineering training center, Harbin University of Science and Technology, Harbin, Heilongjiang, China
2 Gemini Technologies inc, Egg harbor township, NJ, USA
3 Rutgers, The State University of New Jersey, Piscataway, NJ, USA
a Corresponding author: jingnanzhao_cee@yahoo.com
The 3D model of centrifugal pump impeller in Unigraphics (UG) was optimized by implementing the principles of NURBS curve interpolation. The impeller was then manufactured by rapid prototyping equipment using polystyrene. The technique improves the efficiency in innovative design, modification, and fabrication.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.