Issue |
MATEC Web Conf.
Volume 278, 2019
2018 2nd International Conference on Building Materials and Materials Engineering (ICBMM 2018)
|
|
---|---|---|
Article Number | 01005 | |
Number of page(s) | 4 | |
Section | Building Materials and Applications | |
DOI | https://doi.org/10.1051/matecconf/201927801005 | |
Published online | 08 April 2019 |
Application of the High Early Strength Type Expansive Agent to the Blast Furnace Slag Combination Concrete with GGBFS under Steam Curing
1
Tokai University Master student
2
Taiheiyo Materials Corporation
3
Tokai University
In recent years, the use of blast furnace slag material is being focused as environmental loading reduction and sustainable construction. However, in general, autogeneours shrinkage of the concrete using much amount of GGBFS is large in compared to normal concrete, therefore risk of cracking should be cared. On the other hand, strength development speed of concrete at early stage will be decreasing as the dosage of GGBFS increases, even under steam curing condition. It can be considered these points will be significant disadvantage in both productivity and quality of precast concrete. So in this study, early strength type expansive agent and setting accelerator were used in combination. As a result, it was confirmed that compressive strength at early stage is obviously increased. And steam curing temperature can be reduced about 10 degrees, and also, 600×10-6 of restraint expansion was obtained.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.