MATEC Web Conf.
Volume 265, 2019International Geotechnical Symposium “Geotechnical Construction of Civil Engineering & Transport Structures of the Asian-Pacific Region” (GCCETS 2018)
|Number of page(s)||8|
|Section||Foundations and Underground Structures|
|Published online||30 January 2019|
Compliance of a rigid joint of a steel column of I-section on a rigid foundation
Peter the Great St. Petersburg Polytechnic University, 195251 St. Petersburg, Russia
2 Moscow State University of Civil Engineering, Yaroslavskoye shosse, 26, Moscow, 129337, Russia
* Corresponding author: firstname.lastname@example.org
The article considers the compliance of a rigid assembly of a steel column of a typical I-section under the loads of an eccentric-compressive load with a random eccentricity. A simplified scheme of pinching a rigid hinge is considered as well as its detailed version in which the rigid part of the rod is elaborated as a basement, foundation plate, cross-arm and anchor bolts with plates. The authors carried out numerical studies of this site using a computer complex Abaqus 2017. Analysis of the results showed that the inclusion of compliance at a sufficiently accurate numerical simulation gives the same value for compressive forces. Thus, this node can be considered rigid, and the coefficient of buckling is almost equal to the theoretical value.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Initial download of the metrics may take a while.