MATEC Web Conf.
Volume 254, 2019XXIII Polish-Slovak Scientific Conference on Machine Modelling and Simulations (MMS 2018)
|Number of page(s)||6|
|Section||Experimental Mechanics, Identification and Validation|
|Published online||15 January 2019|
Testing of a torque sensor used to measure the parameters of the briquetting process of lignocellulosic materials
Chair of Basics of Machine Design, Poznan University of Technology, Poznan, 60-965, Poland
* Corresponding author: firstname.lastname@example.org
The study presents a control and measurement system for the drive parameters of screw compactor machine with open working chamber for shredded materials. The study demonstrates the construction and working principle of the torque sensor for measuring the torque of the motor driving the compacting screw. The calibration method for the measuring system was presented together with example measurement results for compaction of broken up rye straw, oat straw and hay. The study results were analyzed for feasibility of use for the compaction of materials with specific thermomechanical properties. The conclusion presents the possible forms of application of the established solution in mass production.
Key words: worm/screw-based compaction machine / torque sensor
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.