Issue |
MATEC Web Conf.
Volume 199, 2018
International Conference on Concrete Repair, Rehabilitation and Retrofitting (ICCRRR 2018)
|
|
---|---|---|
Article Number | 09014 | |
Number of page(s) | 8 | |
Section | Structural Repair Materials and Systems | |
DOI | https://doi.org/10.1051/matecconf/201819909014 | |
Published online | 31 October 2018 |
Basalt reinforced concrete structures for retrofitting concrete surfaces
1
University of Applies Sciences Munich, Faculty of Civil Engineering, Karlstraße 6, D-80333 Munich, Germany
2
Laboratory for steel and light metal construction University of Applies Sciences Munich, Karlstraße 6, D-80333 Munich, Germany
* Corresponding author: benjamin.wolf@hm.edu
Reinforced concrete facades exist since decades exposed to natural weather conditions. Thus nowadays lot of them are damaged by carbonation induced corrosion and therefor require repairing and retrofitting. The aim of this research project is to investigate the possibilities of basalt fibre reinforced concrete as repairing material and also basalt rebars as additional strengthening reinforcement. Investigations with basalt fibre reinforced mortar prisms showed best results in 3 point bending tests, tensile strength and also compressive strength using 0.3 Vol.-% basalt fibres in mixture. The mechanical properties of basalt rebars made of basalt fibre reinforced polymer were tested, showing higher values in tensile strength and Young´s Modulus than comparable steel reinforcement samples. The basalt rebar reinforced concrete samples achieved higher ultimate loads in three-point bending test compared to SRC samples. But after failure in the bonding area no residual load capacity remained. Finally basalt reinforcement bars seems to be well suited for use as retrofitting material for facade elements, but numerous properties have to be examined in further investigations.
© The Authors, published by EDP Sciences, 2018
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.