Macrocell corrosion between crossed steel rebars embedded in concrete under chloride environments

¹ Key Laboratory of Performance Evolution and Control for Engineering Structures, Ministry of Education
² Department of Structural Engineering, College of Civil Engineering, Tongji University, No. 1239 Siping Rd., Shanghai 200092, PR China

^* Corresponding author: gxl@tongji.edu.cn

Abstract

Steel reinforcement corrosion is found to be more severe at stirrups or some intersection zones of steel rebar mesh in concrete structures subjected to chloride penetration. This can be caused by macrocell corrosion formed between steel rebars with different potentials. Such potential differences are usually contributed by 1) chloride concentration gradients during the penetration process and 2) material differences between crossed steel rebars. With the forming of macrocell corrosion, the anodic current of steel with more negative potential will increase. The present study aims to deal with the macrocell corrosion between crossed steel macro-couples by dividing the steel rebar into intersected zone (IZ) and non-intersected zone (NIZ). The distribution of macrocell current on the surfaces of NIZ was obtained by means of a transmission line model. Based on the calculated macrocell current, the influence of the macrocell corrosion on the service life of reinforced concrete (RC) structures was analyzed. The results showed that the coupled micro- and macro-cell corrosion of stirrups could accelerate the change of the failure mode of a beam from bending to shear failure when the macrocell corrosion rate was no less than the microcell corrosion rate.