Issue |
MATEC Web Conf.
Volume 139, 2017
2017 3rd International Conference on Mechanical, Electronic and Information Technology Engineering (ICMITE 2017)
|
|
---|---|---|
Article Number | 00174 | |
Number of page(s) | 4 | |
DOI | https://doi.org/10.1051/matecconf/201713900174 | |
Published online | 05 December 2017 |
Modeling and Predicting Cross-sectional Surface Roughness for the Grinding Process
School of Mechanical Engineering, Hunan Industry Polytechnic, Changsha 410082, China
* Corresponding author: 715847062@qq.com
This paper proposes a new algorithm for predicting the cross-sectionalsurface roughnesst of the workpiece for the grinding process, which reduces three-dimensional modeling to two-dimensional modeling by virtue of the cross-sectional area of the undeformed grinding chip. Besides, this paper develops a search technique to figure out systematically the surface roughness in order to determine the final cross-sectional surface roughness produced by thousands of grinding wheel grains with randomly distributed protrusion heights. The simulated results are consistent with the measurement data, which proves the effectiveness of the proposed algorithm.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.