Issue |
MATEC Web Conf.
Volume 126, 2017
Annual Session of Scientific Papers IMT ORADEA 2017
|
|
---|---|---|
Article Number | 04008 | |
Number of page(s) | 4 | |
Section | Management And Economic Engineering | |
DOI | https://doi.org/10.1051/matecconf/201712604008 | |
Published online | 09 October 2017 |
Case study using analysis of variance to determine groups’ variations
CONTINENTAL Automotive, flavius.a.ardelean@continental-corporation.com
* Corresponding author: flavius.a.ardelean@continental-corporation.com
This paper aims to present the analysis of a part manufactured in three shifts, which has a specific characteristic dimension, using DFSS (Design for Six Sigma) ANOVA (Analysis of Variance) method. In every shift, the significant characteristic, “SC”, dimension should be produced within the given tolerance. The question that arises is: “Does the shift have any influence on the “SC” dimension realization?” By using the one way ANOVA method, one can observe the variation between the means of each of the three shifts. Afterwards, specific action can be undertaken to adjust, if necessary, the differences between the shifts.
© The authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.