Comparative analysis of results from experimental and numerical studies on concrete strength

Moscow state university of civil engineering, Yaroslavskoye shosse, 26, Moscow, Russia, 129337

^* Corresponding author: sergey.bulushev@gmail.com

Abstract

Some results of numerical experiments of testing concrete cubes and prisms on unconfined compression, and the comparison of results obtained with experimental and specified data, are presented in the article. When performing calculations of structures in a nonlinear setting, it is very important to choose adequate deformation diagrams or material models. Because of the fact that there are no instructions how to use the diagrams of concrete and armature deformation in collaboration of steel and concrete, the simulation of reinforced concrete structures by finite elements of the same type without any assumptions is impossible. Numerical experiments have been performed in the LS-DYNA software package. This software package allows simulating the collaboration of concrete and steeling with the help of three-dimensional (for concrete) and rod (for the reinforcement) finite elements. As samples, a cube and a prism with dimensions of 150×150×150 mm and 150×150×600 mm, respectively, have been taken. The samples are simulated by solid finite elements. For the simulation of concrete, the non-linear CSCM (Continuous Surface Cap Model) material is used. The tests were carried out with samples of the following classes of concrete as for cylinder compressive strength: C12, C16, C20, C25, C30, C35. This corresponds to the following classes of cube compression strength: B15, B20, B25, B30, B37, B45. The tests have been carried out considering the friction coefficients between the plates of a testing machine, and a sample. The performed researches have shown that the destruction nature of the samples in a numerical experiment corresponds to the failure nature in real tests. The investigated model of CSCM concrete can be used in the calculation of concrete and reinforced concrete structures with acceptable accuracy for main classes of concrete.