| Issue |
MATEC Web Conf.
Volume 115, 2017
XXXIII Siberian Thermophysical Seminar (STS-33)
|
|
|---|---|---|
| Article Number | 03014 | |
| Number of page(s) | 4 | |
| Section | Chapter 3 Transport processes in physical and chemical transitions, including combustion | |
| DOI | https://doi.org/10.1051/matecconf/201711503014 | |
| Published online | 10 July 2017 | |
Studies of ignition and combustion of coals subjected to electrochemical activation
1 Institute of Thermophysics SB RAS, Novosibirsk, Russia
2 Open joint-stock company Sibtechenergo, Novosibirsk, Russia
* Corresponding author: temkansu@yandex.ru
Coal is one of the most important energy sources in the world. According to forecasts, by 2020, the share of coal in the global energy sector will reach 50%, primarily due to the very likely reduction in oil and gas consumption, as well as the revision of the policy on the development of nuclear energy. For thermal power plants with pulverized-coal boilers, a problematic economic and technological issue is ignition and lighting, carried out with high-reaction fuel - gas, fuel oil, and diesel fuel. The cost of this fuel is much higher than the cost of coal itself, which means that the introduction of new technologies that allow excluding petroleum products from the energy processes that take place at the CHP plant is topical [1]. In this paper, the technology of electrochemical ignition, which is an alternative to gas and fuel oil ignition of power boilers, is studied.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.