| Issue |
MATEC Web Conf.
Volume 115, 2017
XXXIII Siberian Thermophysical Seminar (STS-33)
|
|
|---|---|---|
| Article Number | 02009 | |
| Number of page(s) | 4 | |
| Section | Chapter 2 Turbulent flows, heat and mass transfer in single-phase flows, heat transfer enhancement | |
| DOI | https://doi.org/10.1051/matecconf/201711502009 | |
| Published online | 10 July 2017 | |
Experimental investigation of the influence of the passive porous coating on laminar-turbulent transition of the hypersonic boundary layer of the sharp cone at angles of attack
Khristianovich Institute of Theoretical and Applied Mechanics SB RAS, 630090 Novosibirsk, Russia
* Corresponding author: morozov@itam.nsc.ru
The problem of the delaying laminar to turbulent transition by the passive porous coating on the sharp cone at the angle of attack has been studied for the first time. Experiments are conducted in a Transit-M hypersonic short-duration wind tunnel at the Mach number 5.9. The boundary layer laminar-turbulent transition is determined by heat flux distribution on the surface of the cone. It is found that the transition on the porous surface in compare to smooth surface has been delaying on the windward side at the 0.5°, 1° and on leeward side at the 0.5°. There is no effect of the porous coating on the location of the laminar to turbulent transition at angle of attack 1°.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.