| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 09014 | |
| Number of page(s) | 6 | |
| Section | Industrial and Product Management, Quality and Evaluation | |
| DOI | https://doi.org/10.1051/matecconf/201711209014 | |
| Published online | 03 July 2017 | |
Study on the design of industrial control valves with manual drive
“Gheorghe Asachi” Technical University, Iași, România
* Corresponding author: andrey_octavian@yahoo.com
The paper presents the main components and the operating mode of the manually operated control valves used in natural gas transport and distribution installations. Main parameters are specified: inlet-outlet pressure (P), temperature(T), flow rate (Q), which are taken into considerations from the design phase and beyond. Noise is another parameter, in close liaison with the pressure and flow. As their value increases with both the inlet noise levels downstream of the valve is greater. By optimizing internal components, especially cages, noise can be limited below the maximum allowed by regulations. Also, there are presented control valve constructive types so that the optimal variant can be chose.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.