| Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
|---|---|---|
| Article Number | 07015 | |
| Number of page(s) | 6 | |
| Section | Mechanical and Manufacturing Equipment, Devices and Instrumentation, Design and Analysis | |
| DOI | https://doi.org/10.1051/matecconf/201711207015 | |
| Published online | 03 July 2017 | |
Tooth contact analysis of spur gears. Part 1-SAM analysis of standard gears
Technical University of Iaşi, Mechanical Engineering Department, 63 D. Mangeron St., Iaşi, Romania
* Corresponding author: spcretu@tuiasi.ro
The involute gears are sensitive to the misalignment of their axes which determines transmission errors and perturbations of pressures distributions along the tooth flank. The concentrated contacts in gears are no longer as Hertz type. A semi-analytical method was developed to find the contact area, pressures distribution and depth stresses state. The matrix of initial separations is found analytically for standard and non-standard spur gears. The presence of misalignment as well as the flank crowning and flank end relief are included in the numerical analysis process.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.