Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
---|---|---|
Article Number | 01024 | |
Number of page(s) | 6 | |
Section | Advanced Machining and Surface Engineering | |
DOI | https://doi.org/10.1051/matecconf/201711201024 | |
Published online | 03 July 2017 |
Experimental studies on drilling in cryogenic conditions the industrial plastic parts
1 Technical University of Cluj-Napoca, North University Center Baia Mare, Dr. V. Babeş str., 62A, 430083, Baia Mare, România
2 University of Nyíregyháza, Institute of Engineering and Agricultural Sciences, Sóstói út 31/B, 4400, Hungary
* Corresponding author: Ravai.Nagy.Sandor@cunbm.utcluj.ro
Starting from an identified industrial need, therefore to process plastics in certain accuracy classes with machining time as low as possible, we studies performed in the field of plastic processing in cryogenic conditions. To parameterize the cutting potential of the industrial plastics with low rigidity in cryogenic conditions, the tests where we made was an exploratory character. During the experiments, we followed the variation of feed forces and cutting torque as well as the machining precision. We noticed an improvement in chip remove capacity of the tool and increased machining accuracy, due to low temperatures used during the processing.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.