Issue |
MATEC Web Conf.
Volume 112, 2017
21st Innovative Manufacturing Engineering & Energy International Conference – IManE&E 2017
|
|
---|---|---|
Article Number | 01003 | |
Number of page(s) | 6 | |
Section | Advanced Machining and Surface Engineering | |
DOI | https://doi.org/10.1051/matecconf/201711201003 | |
Published online | 03 July 2017 |
Productivity improvement of the water meter’s body manufacturing process
1 Opole University of Technology, Faculty of Mechanical Engineering, 76 Proszkowska Street, 45-758 Opole, Poland
2 Poznan University of Technology, Faculty of Mechanical Engineering and Management, 3 Piotrowo Street, 60-965 Poznan, Poland
* Corresponding author: j.krolczyk@po.opole.pl
In the paper, the water meter’s body manufacturing process, in the aspect of its productivity improvement was analyzed. The analysis was focused on the identification of the fundamental problems of manufacturing company, related to the productivity, and subsequently on the ideas of their elimination (alternatively limitation). The paper was focused on the analysis of problems influencing productivity and ideas of their elimination. The experimental research results related to the productivity, generation of production shortages and also the dimensional deviations of the water meter’s body were also presented.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.