Issue |
MATEC Web Conf.
Volume 97, 2017
Engineering Technology International Conference 2016 (ETIC 2016)
|
|
---|---|---|
Article Number | 01076 | |
Number of page(s) | 5 | |
DOI | https://doi.org/10.1051/matecconf/20179701076 | |
Published online | 01 February 2017 |
Observation of Built-up Edge Formation on a Carbide Cutting Tool with Machining Aluminium Alloy under Dry and Wet Conditions
1 Faculty of Engineering Technology, Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
2 Faculty of Manufacturing Engineering, Universiti Teknikal Malaysia Melaka (UTeM), Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
3 Faculty of Engineering Technology, Universiti Malaysia Perlis (UniMAP), Aras 1, Blok S2, Kampus UniCITI Alam Sungai Chuchuh, Padang Besar, 02100 Perlis, Malaysia
* Corresponding author: umar@utem.edu.my
This paper presents the morphology of built-up edge (BUE) formation under wet and dry conditions with low and high cutting speeds. The workpiece materials and cutting tools selected for this work were aluminium alloy and canela carbide inserts graded PM25. The cutting tools underwent turning operation machining tests and their performance was evaluated by the flank wear and observation of the tool wear area. The machining tests were conducted at different spindle speeds and feed rates while the cut depth was kept constant. The analysis showed that formation of the BUE was dominant at low cutting speeds in dry conditions, but in wet conditions at high cutting speeds, a better performance was exhibited in terms of wear analysis.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.