| Issue |
MATEC Web Conf.
Volume 87, 2017
The 9th International Unimas Stem Engineering Conference (ENCON 2016) “Innovative Solutions for Engineering and Technology Challenges”
|
|
|---|---|---|
| Article Number | 02012 | |
| Number of page(s) | 5 | |
| Section | Mechanical Engineering | |
| DOI | https://doi.org/10.1051/matecconf/20178702012 | |
| Published online | 12 December 2016 | |
Optimisation of electrospinning parameter for Poly(L-lactic) acid (PLLA) electrospun nanofiber
Faculty of Engineering, Universiti Malaysia Sarawak, 94300 Kota Samarahan
Poly (L-lactic) Acid (PLLA) ia one of the biodegradable polymer that normally used in the biomedical application. In this work it is shown that electrospinning of PLLA electrospun fibre was affected by electrospinning processing parameters such as the solvent systems selection, polymer solution concentration, flow rate and acceleratingvoltage. Optimisation of these parameters is necessary to obtain a beadless and submicron diameter fibre as desired in this research.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.