MATEC Web Conf.
Volume 85, 2016Chemistry and Chemical Technology in XXI Century (CCT 2016)
|Number of page(s)||7|
|Published online||17 November 2016|
Rheological properties of inverse emulsions stabilized by ethanolamides of tall oil fatty acids
1 Siberian Physical-Technical Institute of Tomsk State University, 1 Novosobornaya sq., Tomsk, 634050, Russia
2 Seversk Technological Institute of National Research Nuclear University “MEPhI”, 65 Kommunisticheski avenue, Seversk, 636036, Russia
3 National Research Tomsk Polytechnic University, 30 Lenin Ave., Tomsk, 634050, Russia
* Corresponding author: mailto: email@example.com
The paper presents the comparative analysis of inverse emulsion rheological behavior stabilized by monoethanolamide and diethanolamide of tall oil fatty acids, which are promising reagents for petroleum engineering. Flow curves of emulsions and volume ratio of dispersed phase have been obtained. The analysis of the dependence of Herschel–Bulkley model parameters on concentration of emulsifiers has been carried out. It is proved that emulsifiers affect weakly on the rheological parameters in high water phase content emulsions, while in cut-back emulsions their impact is registered to be stronger. It has been found that rheological parameters of the emulsions stabilized by monoethanolamide throughout the range of concentration are considerably higher than the samples on the base of diethanolamide. The experimental data proved the key impact of viscosity of dispersion medium on rheological behavior of cut-back emulsions.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.