| Issue |
MATEC Web Conf.
Volume 78, 2016
2nd International Conference on Green Design and Manufacture 2016 (IConGDM 2016)
|
|
|---|---|---|
| Article Number | 01024 | |
| Number of page(s) | 6 | |
| DOI | https://doi.org/10.1051/matecconf/20167801024 | |
| Published online | 07 October 2016 | |
Optimization of Machining Parameters for Minimization of Roundness Error in Deep Hole Drilling using Minimum Quantity Lubricant
1 Soft Computing Research Group, Faculty of Computing, Universiti Teknologi Malaysia, 81310 UTM, Skudai, Johor, Malaysia
2 Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, 81310 UTM, Skudai, Johor, Malaysia
* Corresponding author: anisfarhankmi@yahoo.com
This paper presents an experimental investigation of deep hole drilling using CNC milling machine. This experiment investigates the effect of machining parameters which are spindle speed, feed rate and depth of hole using minimum quantity lubricant on the roundness error. The experiment was designed using two level full factorial with four center point. Finally, the machining parameters were optimized in obtaining the minimum value of roundness error. The minimum value of roundness error for deep hole drilling is 0.0266 at the spindle speed is 800 rpm, feed rate is 60 mm/min, depth of hole is 70 mm and minimum quantity lubricant is 30ml/hr.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.