Issue |
MATEC Web Conf.
Volume 67, 2016
International Symposium on Materials Application and Engineering (SMAE 2016)
|
|
---|---|---|
Article Number | 03004 | |
Number of page(s) | 6 | |
Section | Chapter 3 Information Technology | |
DOI | https://doi.org/10.1051/matecconf/20166703004 | |
Published online | 29 July 2016 |
The Upper Beam Tryout Process Combined with Finite Element Simulation and Experiment
1 School of Mechanical Engineering, Xi&an Jiaotong University, ShaanXi 710049, P.R.China
2 TianJin Engineering Center of Digital Manufacturing Die and Mold, Tianjin University of Technology and Education, Tianjin 300222, P.R.China
3 State Key Laboratory for Manufacturing Systems Engineering, Xi&an Jiao tong University, Shan’xi 710049, P.R.China
4 Guangdong Shunde Xi&an Jiaotong University Academy, guangdong 528000, P.R.China
a yuqiang95@yeah.net
b liangjin@mail.xjtu.edu.cn
* Corresponding author: yuqiang95@yeah.net
An upper beam is investigated by combination of finite element simulation and tryout methods. The results of deformation simulation and grid experiment were studied. The results show that the direction of principal and side strain in the crack area simulated by CAE software are same as the results received by grid experiment. The result gives a direction for solving the crack problems. It is important that the blank size in both ends is reduced to decrease the bending stress in the die radius. But the effect is very limited for the end region is far from crack area. Combined with the method of reducing the blank size, decreasing the height of the drawbead, enlarging the die radius, improving the smoothness the tension stress is decreased effectively. And the qualified drawing panel is produced finally.
© The Authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.