| Issue |
MATEC Web of Conferences
Volume 45, 2016
2016 7th International Conference on Mechatronics and Manufacturing (ICMM 2016)
|
|
|---|---|---|
| Article Number | 04001 | |
| Number of page(s) | 5 | |
| Section | Machinery manufacturing and automation | |
| DOI | https://doi.org/10.1051/matecconf/20164504001 | |
| Published online | 15 March 2016 | |
A development of the method of the control signal formation for the hot plate mill automation systems to improve the flatness of the finish plate
South Ural State University (National Research University), 454080, Lenin ave. – 76, Chelyabinsk, Russian Federation
This article describes how to control of the hot plate mill automation system to improve the quality metrics if the final strip. Based on the data of the modern hot rolling mills the classification of the cage equipment was designed. Depending on the degree of influence on the magnitude of reduction, the equipment was divided into categories. The functioning of every system including the main and the vertical cages was described. The conditions of electrical and hydraulic mechanisms was marked. The developed algorithm allows to improve defects based on the finite number of the thickness measurements given by special non-contact sensors. The example of regulators signals calculating was shown. The result of the algorithm operating was illustrated.
© Owned by the authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.