| Issue |
MATEC Web of Conferences
Volume 45, 2016
2016 7th International Conference on Mechatronics and Manufacturing (ICMM 2016)
|
|
|---|---|---|
| Article Number | 01004 | |
| Number of page(s) | 5 | |
| Section | Materials processing and Applications | |
| DOI | https://doi.org/10.1051/matecconf/20164501004 | |
| Published online | 15 March 2016 | |
Formulation of Forming Load in V-Bending
Dept. of Mechanical Engineering, Gifu University, 1-1 Yanagido, Gifu, 501-1193, Japan
A novel method is described to calculate the forming load in V-bending by a press brake. The data of forming load are collected by FEM analysis. With an increase of the punch stroke in V-bending, the forming load increases gradually after the elastic limit, and then decreases after showing the maximum value. The proposal formulation to trace the variations in the forming load curve includes the calculating method of the load of the elastic limit, the maximum load in air bending and the variations of the forming load before/after the bending stroke of the maximum load. The calculated precision is confirmed by comparing with the measured load-stroke curves in V-bending with a press brake.
© Owned by the authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.