| Issue |
MATEC Web of Conferences
Volume 31, 2015
2015 7th International Conference on Mechanical and Electronics Engineering (ICMEE 2015)
|
|
|---|---|---|
| Article Number | 07001 | |
| Number of page(s) | 8 | |
| Section | Sensor and measurement technology | |
| DOI | https://doi.org/10.1051/matecconf/20153107001 | |
| Published online | 23 November 2015 | |
Sensorless Control Technology for PMSG base on the Dead-time Compensation voltage
North China University of Technology, China
a Corresponding author: zhaifei523@163.com
In order to improve the speed sensorless-control system of PMSG in low speed performance, this paper introduces a novel Dead-time compensation control method .Mathematical model is established according to the Dead-zone of the influence of the voltage source type inverter output voltage. At the same time, the given value of current regulator output voltage has been fixed based on the established model. Then the stator voltage after compensationed is applied to the flux estimation, which improves the performance of flux estimation. Finally, the position and speed of the rotor is estimated based on Back-Electromotive Force, which has Simple algorithm and good robustness. In order to verify the correctness of theoretical analysis, the experiment was done according to the new control method. The results proved the correctness and feasibility of this control method.
Key words: Permanent Magnet Synchronous wind power Generator / Back Electromotive Force / Dead-time voltage Compensation / Flux Estimate
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.