| Issue |
MATEC Web Conf.
Volume 192, 2018
The 4th International Conference on Engineering, Applied Sciences and Technology (ICEAST 2018) “Exploring Innovative Solutions for Smart Society”
|
|
|---|---|---|
| Article Number | 02038 | |
| Number of page(s) | 4 | |
| Section | Track 2: Mechanical, Mechatronics and Civil Engineering | |
| DOI | https://doi.org/10.1051/matecconf/201819202038 | |
| Published online | 14 August 2018 | |
Design analysis of a hot strip mill runout table bed under ANSYS workbench
School of Mechanical Engineering, Kalinga Institute of Industrial Technology Deemed to be University, Bhubaneswar-24, India
*
Rudrajit Sinha: rudrajit94@gmail.com
A structural analysis has been performed on the setup of a spray cooling system for a model of a hot strip mill. The objective was to design a run out table (ROT) whose length is reduced for a spray cooling system. The setup consists of a bed (ROT) whose height can be adjusted as desired, and a carriage which would be carrying the hot plate, moving along the bed, for experimentation. The CAD modelling was done in CATIA and the analysis was performed in ANSYS Workbench. A prototype of the whole setup was built from the virtual model and was controlled using products from National Instrument Corporation (NI). The analysis is being conducted for the design optimization of the entire setup and its safety.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.