Coordination Control Strategy for Compound Fault of MMC-HVDC
School of Electrical and Information Engineering, Lanzhou University of Technology, Lanzhou, China
2 Lanzhou Petrochemical Company Power Plant, Lanzhou, China
a Corresponding author: email@example.com
Single-line to ground fault of DC side and sub-module fault are typical faults of MMC-HVDC. When each of the above faults occurs, the system will give a signal for circuit-breaker releasing, this will result in interruption of power delivery, the stability of the system is greatly reduced. When these two faults occur simultaneously, research on control strategy for compound fault will help to improve the reliability of the system. While single-line to ground fault of DC side happens, only the electric potential auxiliary point of DC side is changed, system’s power transport normally. When sub-module is fault, redundancy fault-tolerated control strategy is presented, which replace the failed sub-modules with equal number of redundant sub-modules, it can restrain the fluctuation of direct current. A double terminals and 21 voltage-level MMC-HVDC system simulation model is set up in PSCAD/EMTDC. From the computation and simulation results, it is concluded that the proposed control strategy is correct for above compound fault, it can achieve rapid recovery after faults, effectively improve fault tolerance of the system, develop the stability and reliability of the system.
© Owned by the authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.